91
Feature Requests and Issues / Re: Time Keeping Screen
« on: February 03, 2011, 08:32:41 AM »
Same problem on different computer.
Show Posts
This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.
92
Feature Requests and Issues / Re: Time Keeping Screen
« on: February 03, 2011, 06:46:28 AM »
Firefox, but I tried it while run IE and got the same issue. I'll try it on a different computer and see what I get.
93
Feature Requests and Issues / Re: Time Keeping Screen
« on: February 01, 2011, 04:18:11 PM »
The dates are all correct - Start = 1/1/11 End = 2/1/11 Open = 1/1/11 and the event date is 1/4/11. It will show just not the first time I go into my screen. If I select another member and than back to mine the event shows.
94
Feature Requests and Issues / Time Keeping Screen
« on: February 01, 2011, 07:12:04 AM »
When I first go into the time keeping screen and select my name it does not show the first event that I have entered. If I select "add event" or go to someone elses name and back to mine the first event pops up and stays there until I leave the time keeping screen and than it starts all over again. The first event is within the time limits that I have set at the bottom of the screen.
It shows on the printout report all the time, just not on the screen.
Thanks
It shows on the printout report all the time, just not on the screen.
Thanks
95
Feature Requests and Issues / Reports
« on: January 05, 2011, 06:59:59 AM »
FYI
Under the "Report" tab when I try to print both the member roster and the certification status I get a blank report. When I print these under the "member" tab I get the correct information.
Under the "Report" tab when I try to print both the member roster and the certification status I get a blank report. When I print these under the "member" tab I get the correct information.
96
Feature Requests and Issues / Re: Feature Request
« on: January 01, 2011, 04:00:45 PM »
Yes it works now. I had overwritten the "sample" members and apparently it hadn't changed the unit for them somewhere.
Thanks for the quick fix.
Thanks for the quick fix.
97
Feature Requests and Issues / Re: Feature Request
« on: December 31, 2010, 06:52:36 AM »
Question - I set a member up for limited access and marked that she read only other members and I check all the boxes for members except "none". When she logs on she on sees 11 of the 24 members I have entered. I have looked at each members record and don't see anything that would cause this. Do you have an idea of where I have messed up?
98
Feature Requests and Issues / Re: Feature Request
« on: December 30, 2010, 12:19:57 PM »
I notice on one of the reports under the Certs and Expirations that the Sworn level comes up as the old value of a number instead of what I customized the program to list. On the members page with full access it shows correctly with read only it shows it as a number value.
99
General Mission Manager Discussion / Re: Getting Started with Mission Manager
« on: December 30, 2010, 07:47:56 AM »
I added 3 other members to help evaluate the program. When I added them as "new" the program told me that an email notification was sent. The 3 members tell me they never got an email. When they ask for a password reset they are told their email is not in the system. What do I need to do to get them into the system?